请帮忙审一下BQ76952原理图

您好，请参考下面的回复：

The top cell must be used for BQ76952, so R104 perhaps should not be installed and the short would be more appropriate at cell 13.
The Cc capacitors (C133, etc) are commonly 220 nF.
The right side of C141 should connect to GND rather than VC0 to avoid pushing VC0 below GND during a heavy load on the cells.
D120 is unusual, BQ76952 should not need the component, if it conducts from BAT pin load it may result in a low voltage report of cell 16.
A cap may be desired on the Q100 collector, it can avoid transients coupled through the transistor.
The REGIN cap C154 is recommended to be 22 nF
The BQ76952 data sheet does suggest a 10M pull down on BREG if shutdown is used.
If REG2 is not used it does not need a cap, it would not be configured.
ALERT does not need the pull down R312, but the designer may want it for their system use.
TS1 and TS2 should not go much above 1.8V if used for thermistor or ADC inputs. The D310 and D323 ratings seem high. A small capacitor may be used for transient suppression, see the data sheet
The FET outputs are not shown connected, but CP1 is supported. If not needed CP1 can be shorted to BAT pin.
PACK is an input and should be connected either low or through a 10k resistor to a high voltage.
LD has several functions, it may be controlled or tied low or to a high voltage through a 10k resistor.
FUSE has an input function, if not used the pin might be connected to VSS to avoid the status changing when the pin floats.