BQ76952: 写寄存器协议与例程不符 写不进去

您好，正在查看，稍后回复。

好的 谢谢  

你好 现在就用常规的例程里面的写寄存器 或者用EV2300都是写不进去的  EV2400可以写入  但是抓取的协议完全是不一样的  

您好，请参考下面内容:

I recommend reading the BQ769x2 Software Development Guide for some examples of communicating with the device.

Could you provide more details about these captures? Specifically what commands the host is trying to send in each capture. Also, it looks like the last capture is zoomed out too much so that the bytes are not fully displayed.

One thing to note is that bqStudio will normally handle entering and exiting config update mode and sending the checksum when writing to registers. It may appear different due to this.

你好 这是我单片机写76952的往PowerConfig的寄存器里写入0x2D80的数据，抓取的数据，用上位机看读取出来没有写进去，用EV2400上位机写进去抓到的数据  

您好，建议您用评估板做一下相同的参数写入，是否能成功。