1.I have encountered some problems, the manual says that you should use little endian write command, but the configuration given in the manual section 7.1 is big endian, which one should I use?
2.Do I need to use the bigendian and little endian order depending on the condition?
1.I have a fully charged 4.2V, 2000mAh battery. How should I configure the battery to be fully charged at 4.2V and 2000mAh, at 3.0V is zero percent charge.
2.Do I follow the steps here and the chip starts learning automatically? Or what command do I need to turn on automatic learning?
3.Does the chip have a dmoe program to refer to?
您好，请参考下面文档第三步，打开 BQSTUDIO 进行通信及参数配置。
BQStudio的GPC CYCLE 可以learning automatically
sample code请参考下面链接的内容
