Hello! I compared the AD and PCB in the TIDM-02013 reference design. I found that in the BOM table, L19 was shown as 0, but on the PCB board, L19 was displayed. I don't know if L19 is used in this reference design.
Hello! I compared the AD and PCB in the TIDM-02013 reference design. I found that in the BOM table, L19 was shown as 0, but on the PCB board, L19 was displayed. I don't know if L19 is used in this reference design.
Thank you for contacting TI China E2E forum and choosing our products as part of your solution.
Regarding your query, L19 is reserved and is not mounted for this reference design.
You do not need to think about it.
Thanks.
