DM6467 DVEVM板开发，连接仿真器，用ccs测试连接时，出现错误“Device is held in reset. Take the device out of reset, and retry the operation.”

我已经添加了这个文件，还是报错，我之前添加的是C:\ti\ccsv8\ccs_base\emulation\boards\evmdm6467\gel\davincihd1080p_arm.gel

这个是我改了之后的界面：

您好，我加了那个文件后还是出现那个错误！

你好，

连接上ARM后是否看到了gel的输出打印？

您好,

有gel的输出打印
输出打印是：

ARM926: GEL Output:
DaVinci HD1080p ARM Startup Sequence

ARM926: GEL Output: Disable IRQ/FIQ
ARM926: GEL Output: Flush Cache
ARM926: GEL Output: Disable MMU
ARM926: GEL Output: Enable Instruction Cache.

ARM926: GEL Output: Setup PinMux...ARM926: GEL Output: [Done]
ARM926: GEL Output: Setup Power Modules (All on)...ARM926: GEL Output: [Done]
ARM926: GEL Output: Setup PLL0ARM926: GEL Output: (DSP = 990 MHz +ARM926: GEL Output: ARM = 247 MHz +ARM926: GEL Output: Onchip Oscillator)...ARM926: GEL Output: [Done]
ARM926: GEL Output: Setup PLL1ARM926: GEL Output: (DDR2 Phy = 396 MHz +ARM926: GEL Output: Onchip Oscillator)...ARM926: GEL Output: [Done]
ARM926: GEL Output: Setup DDR2 (396 MHz + 32-bit bus)...ARM926: GEL Output: [Done]
ARM926: GEL Output:
Startup Complete.

ARM926: GEL Output: Disable VPSS
ARM926: GEL Output: Disable IRQ/FIQ
ARM926: GEL Output: Flush Cache
ARM926: GEL Output: Disable MMU
ARM926: GEL Output: Disable EDMA events
ARM926: GEL Output:
ARM926: GEL Output: Disable VPSS
ARM926: GEL Output: Disable IRQ/FIQ
ARM926: GEL Output: Flush Cache
ARM926: GEL Output: Disable MMU
ARM926: GEL Output: Disable EDMA events
ARM926: GEL Output:

“DaVinci HD1080p ARM Startup Sequence”您用的还是davincihd1080p_arm.gel这个GEL文件吧，重新打开target configuration file看一下gel文件有没有替换成功。

好的，感谢分享！