TDA4VM CAN

请问您使用的是RTOS还是Linux SDK?

RTOS

MCUSW  autosar  接口下的环境

请看一下下面的FAQ。
https://e2e.ti.com/support/processors-group/processors/f/processors-forum/1065173/faq-tda4vm-not-able-to-receive-messages-for-a-particular-can-id-how-to-debug

您好！

         看了相关的链接内容，但是还是不能解决我要问的问题，我是指如何设置过滤接收一段（如：0X400~0X4FF)报文ID的掩码（mask)?

          以上，谢谢！

haoming20220428

请回答一下下面工程师的问题，谢谢！

Can you elaborate on the driver you are referring to inside of MCUSW? You mentioned the "Received Message ID", it sounds like a communication protocol. Also, can you add which SDK version you are using?

hi,

      I am referring to the CAN driver, which needs to filter and receive the CAN ID of a certain network segment (such as 0X400~0X47F), and the SDK package is 8.03 or 8.04 (tda4vl)

haoming20220505

感谢回复问题，已在e2e上更新。

Hi,

       Following your suggestion, I modified the code as follows:

        But still unable to receive any ID in the 0x400~0x47F network segment.

        The MCANSS_RX_BUFFER_ELEM_ID_MASK received at the bottom layer in Mcan.c is 0x1FFFF480U, and it still cannot be received

    Cherry_hm  20220507

已把您的问题更新到e2e论坛，请等待工程师的回复。

非常高兴您的问题解决了！如果方便的话，能否分享一下解决方法？谢谢！

HI,

         需要将 CanHandleType =1(Basic)设置为“1”即可。

          以上，

cherry_hm20220510

非常感谢!