TDA4AL-Q1: How to config PMIC WATCHDOG in software ?

Hi TI,

Q1.
If the LEOA_WDOG_DISABLE pin of PMIC is LOW (Enable WDOG),
How to disable PMIC WATCHDOG in software ?

Q2.
How to feed the PMIC WATCHDOG in software ?
in R5 ?
in A72 uboot code ?
in A72 kernel code ?

Q3.
How to change the timer of PMIC WATCHDOG in software ?
Now it trigger reset after about 13 minutes.
How to change it to 5 minutes ?

Q4.
Is there a software service to feed the PMIC WATCHDOG ?
How to enable the software service ?

Q5.
Is there a document like lp876242-q1.pdf to show the PMIC WODG of TDA4AL-Q1 ?
www.ti.com/.../tda4al-q1.pdf | no find watchdog in this
www.ti.com/.../lp876242-q1.pdf | p.59 - 7.3.8 Watchdog (WD)

=========
others

Watchdog Informational Overview
www.ti.com/.../6313371139112

TDA4VE TDA4AL TDA4VL Jacinto Processors, Silicon Revision 1.0
www.ti.com/.../tda4al-q1.pdf

LP876242-Q1 Four 8.8-MHz Buck Converters for AWR and IWR MMICs
www.ti.com/.../lp876242-q1.pdf
p.59 - 7.3.8 Watchdog (WD)

e2e.ti.com/.../5492020

e2e.ti.com/.../lp876242-q1-how-to-close-the-pmic-watchdog-by-software

Thanks
Jiahao