IWR6843ISK: How to increase the number of people tested?

请参考下面e2e帖子的讨论。
https://e2e.ti.com/support/sensors-group/sensors/f/sensors-forum/829940/iwr6843-people-count-accuracy-improvement-in-iwr6843-radar-sensor

thank you for your reply. No corresponding method can be found for this post. The room is 8 meters wide and 5 meters wide. It is not very accurate to detect two people. I don’t need to track people. I only use it to detect the number of people. What can I do to improve the accuracy of IWR6843ISK ? .

Thanks

你好， 

我使用ISK_6m_default.cfg配置文件测试，还是存在这个问题。 

你好，

ISK_6m_default.cfg的配置是检测范围水平方向-4m~4m，垂直方向0.5m到6m。所以你毫米波板是架在你的房间的8m的中间，对么？因为你的房间另一个方向是5m，请修改检测的范围。

你的sensor是否有按照配置参数架高2m，sensor板向下倾斜15度？

你的房间是空旷的，还是有很多的家具?

你提到的检测2个人不准确，能否录个视频，让我们了解一下到底怎么个不准确。

boundaryBox -4 4 0.5 6 0 3
sensorPosition 2 0 15