CC1312R: 1310迁移到1312的配置问题

faker wang

Part Number: CC1312R
Other Parts Discussed in Thread: CC1310, , SYSCONFIG

ti你好

我们原来使用cc1310,现在因为内存等原因切换到1312,请问我之前在1310上使用的初始化配置如下:

#define CC1310_LAUNCHXL_SPI_ACC_CS IOID_4

static PIN_Config BoardACCPinTable[] =
{
CC1310_LAUNCHXL_SPI_ACC_CS | PIN_GPIO_OUTPUT_EN | PIN_GPIO_HIGH | PIN_PUSHPULL | PIN_DRVSTR_MIN,

PIN_TERMINATE
};

hAccPin = PIN_open(&pinState, BoardACCPinTable);

切换到1312应该如何配置?

如下配置是否正确?

#define CC1310_LAUNCHXL_SPI_ACC_CS IOID_4

GPIO_setConfig(CC1310_LAUNCHXL_SPI_ACC_CS , GPIO_CFG_OUTPUT | GPIO_CFG_OUT_HIGH |GPIO_CFG_OUT_STR_LOW);

11 个月前

0 faker wang 11 个月前

Intellectual 295 points

还有这个spi的配置

const PIN_Config BoardGpioInitTable[] = {
CC1310_LAUNCHXL_UART_RX | PIN_INPUT_EN | PIN_PULLDOWN, /* UART RX via debugger back channel */
CC1310_LAUNCHXL_UART_TX | PIN_GPIO_OUTPUT_EN | PIN_GPIO_LOW | PIN_PUSHPULL, /* UART TX via debugger back channel */
CC1310_LAUNCHXL_SPI0_MOSI | PIN_INPUT_EN | PIN_PULLDOWN, /* SPI master out - slave in */
CC1310_LAUNCHXL_SPI0_MISO | PIN_INPUT_EN | PIN_PULLDOWN, /* SPI master in - slave out */
CC1310_LAUNCHXL_SPI0_CLK | PIN_INPUT_EN | PIN_PULLDOWN, /* SPI clock */

PIN_TERMINATE
};

在1312中是否应该添加到ti_drivers_config.c文件中下面的数组中,我下面的配置应该是错误的,请问正确的配置应该是什么
GPIO_PinConfig gpioPinConfigs[31] = {
GPIO_CFG_INPUT_INTERNAL | GPIO_CFG_INPUT|GPIO_CFG_PULL_DOWN_INTERNAL,

}