DLP LIGHTCRAFTER配件问题

１．你们需要购买mini HDMI线(里面是DＶＩ协议)；

２．如果你们要使用camera触发，需要制作同步触发线,参考文档资料：　

http://www.ti.com/lsds/ti/analog/dlp/technical-documents.page?familyId=1742&docCategoryId=9

• Using the DLP LightCrafter™ to trigger CCD cameras from Imaging Source

3. LightCrafter 3000驱动板现在可以驱动１Ａ(j2连接插座通常没有焊接）和２Ａ（J9插座, max. 5.5V）的确ＬＥＤ；（软件可以调整,参考文档资料http://www.ti.com/tool/dlplightcrafter: DLP® LightCrafter™ User's Guide (Rev. E) ）

4.你们要移除LＥＤ模组,参考文档资料：

http://e2e.ti.com/support/dlp__mems_micro-electro-mechanical_systems/f/850/p/159950/586943.aspx#586943

To remove the light engine follow this procedure:

• remove the system board (top board) by removing the four screws in the corner posts.
  
  
   
• remove the three screws from the top of the light engine, you will need a Phillips P00 screwdriver
   
• remove the four screws on the bottom thermal plate holding the LED heat sinks
   
• remove the ribbon cables from the driver board (bottom board). Just pull-up the plastic tab and pull-up the ribbon cable. Be careful, these ribbons are fragile and easy to break while pulling.
   
  
• remove the two little back screws on the board holding the DMD to the light engine. This is the vertical standing board connected to the driver board
  
  
   
• Gently pull out the light engine. The light engine lies on the support posts, so it needs to be raised a little and gently pulled. The connector of the DMD is in the socket.
   
• Remove the DMD by removing the two P00 screws on the light Engine
  
• Remove the metal plate and carefully remove the DMD. You can mount the DMD on the socket back on the board. Note the notches on the DMD for proper orientation when placing it back on the connector. The large square notch on the package is on the left, while the triangular notch is on the right.

I have re-arranged the boards around to have the DMD without the thermal plate sticking out.