请注意，本文内容源自机器翻译，可能存在语法或其它翻译错误，仅供参考。如需获取准确内容，请参阅链接中的英语原文或自行翻译。
器件型号：BQ34Z100-G1 您好！
我收到了报告、但在报告中没有 chem 文件。 在文件 GPC_report 中、我有
Resistance temperature compensation optimizer, rev=3.48 Optimized Impedance Track parameters: Qmax, mAh : 4308 Ra table normalized to 25C, uncompressed, unscaled DOD, % Ra, mOhm 0 50 11.11 50 22.22 58 33.33 67 44.44 65 55.56 61 66.67 78 77.78 76 80.95 78 84.13 74 87.3 88 90.48 114 93.65 163 96.83 281 100 1194 Ra0_ch, mOhm : 396 This firmware is not explicitly supporting Ra0_ch, FCC drop could occur at low temperatures if used Thermal parameters: T Time Constant 587 T Rise 21.6 Optimized resistance temperature compensation parameters saved in chemdat12 Due to GG file format issues, GG values have not been updated Warning: Automatic firmware properties detection failed. Rb_select defaults to 2. Please make sure that chem ID loaded in the GG file is the same as ID specified in the config.txt Warning: Automatic firmware properties detection failed. basescale defaults to 1. Please make sure that chem ID loaded in the GG file is the same as ID specified in the config.txt
我有一个 DOD_newRb_ratio.txt 文件、其中包含：
0 1.643 0.111 1.728 0.222 1.721 0.333 1.622 0.444 2.431 0.556 2.268 0.667 2.062 0.778 2.062 0.81 2.062 0.841 2.062 0.873 2.062 0.905 2.062 0.937 2.062 0.968 2.062 1 2.062
