This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

[参考译文] TPS5430:Webench 中具有陶瓷输出电容器的增益和相位裕度(以 Webench 为单位)

Guru**** 2389910 points
Other Parts Discussed in Thread: TPS5430
请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。

https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1476659/tps5430-gain-and-phase-margin-in-webench-with-ceramic-output-capacitor

器件型号:TPS5430

工具与软件:

Im 尝试模拟使用陶瓷输出电容器的 TPS5430的波特图。 当在 Webench 电源设计工具中将输出电容器的 ESR 更新为0欧姆时、相位裕度出现故障。 我看过 slva237c 的应用手册以及计算得出的环路补偿电阻器和电容器。 如何在 Webench 的反馈路径中添加环路补偿电阻器和电容器、并查看波特图? 在下面添加了图像以供参考

  • 请注意,本文内容源自机器翻译,可能存在语法或其它翻译错误,仅供参考。如需获取准确内容,请参阅链接中的英语原文或自行翻译。

    尊敬的 Ramesh:

    您能否添加您使用的100uF 电容器具有的 ESR? 没有电容器具有0欧姆 ESR。 另外、在 WebBench 中似乎无法为该部件添加 CFF 和 RFF。

    仿真的最佳路径可能是使用 pspice 并向输出添加负载瞬态、从而查看其在使用您需要的 CFF/RFF 组合时的行为。

    谢谢!

    Andrew