CC3220SF SPI slave模式最高接收速率是多少？

十分感谢

不客气

你好，我还有一个疑问，就是CC3220SF做主机的时候，设置传输时钟的频率：
/*! @brief SPI bit rate in Hz
*
* Maximum bit rates supported by hardware:
* Device Family | Slave Max (MHz) | Master Max (MHz) |
* ------------- | ------------------ | ---------------- |
* MSP432P4 | 16 MHz | 24 MHz |
* MSP432E4 | 10 MHz | 60 MHz |
* CC13XX/CC26XX | 4 MHz | 12 MHz |
* CC32XX | 20 MHz | 20 MHz |
*
* Please note that depending on the specific use case, the driver may not
* support the hardware's maximum bit rate.
*/
uint32_t bitRate;
请问下，CC32XX设置频率与bitRate要怎么设置？
假设我要设置主机频率为15MHZ，那BITRATE要怎么换算？

直接设置你想要的SPI bitrate就行，时钟频率内部自行配置，用户不用操作。使用参考SPIMASTER即可